The Scaler 3 window fits at the top and sides, but is below the bottom of the screen. This means I can’t get to the main chord set. Is there a screen size control somewhere?
The one I found is grabbing the right side of the SC3 window in any point, then grabbing it toward the centre
It works in my system, I hope in your also
You may see a small triangle at the bottom right corner. That’s what I used to resize. hope this helps.
Nope, the OP doesn’t see the corner, like me, because the SC window is too much large: in this case you have to grab the side, NOT the corner
1 Like
Good to know, my friend.
1 Like
Right. The Scaler window extends below the edge of the screen, and I can’t access the bottom corner to grab the triangle.
Grab the side instead, and you are save 
I mean, hover the side until the Selection pointer appears, then pick & grab the side toward the centre
Thank you.
Lol, when I booted the project, Scaler was correctly sized. Don’t know why. The double-sided arrow on the side doesn’t do anything for me … but now I can reach the little arrow shaped thing at the bottom. So all is well for now. Thanks again for your help!
If you right-click on the Scaler logo in the top left corner you can choose “reset to default size” - this fixes the large window issue.
1 Like
If you right-click on the Scaler logo in the top left corner you can choose “reset to default size” - this fixes the large window issue.
Not in my case: the corner is always out of reach
Thank you. That works perfectly.